Introduction to Robot Products

The six-axis robot BRTIRSE2013F is an explosion-proof spraying robot with a 2,000 mm super long arm span and a maximum load of 13kg. The shape of the robot is compact,and each joint is installed with a high-precision reducer, and the high-speed joint speed can carry out flexible operation, it can be applied to a wide range of spraying dust industry and accessories handling field. The protection grade reaches IP65, Dust-proof and water-proof. The repeat positioning accuracy is ±0.5mm.

Basic parameters of robot

Robot trajectory diagram

No further notice if the specification and appearance are changed due to improvement and other reasons. Thank you for your understanding.

Precautions for Storage and Handling Caution:

Do not store or place the machine in the following environment, otherwise it may cause fire, electric shock or machine damage.

1. Places exposed to direct sunlight, places where the ambient temperature exceeds the storage temperature conditions, places where the relative humidity exceeds the storage humidity, or places with large temperature differences or condensation.

2. Places close to corrosive gas or flammable gas, places with a lot of dust, salt and metal dust, places where water, oil and medicine drip, and places where vibration or shock can be transmitted to the subject. Please do not grab the cable for transportation, otherwise it will cause damage or failure of the machine.

3. Do not stack too much products on the machine, otherwise it may case machine damage or failure.

Introduction to Tool Products

The first generation of BORUNTE rotary cup atomizer was based on the principle of using an air motor to drive the rotary cup to rotate at high speed. When the paint enters the rotary cup, it is subjected to centrifugal force to form a conical paint film. The serrated protrusion on the edge of the rotary cup will divide the paint film on the edge of the rotary cup into small droplets. When these droplets fly out from the edge of the rotary cup, they are subjected to the action of atomized air, ultimately forming a uniform and fine mist. Afterwards, the paint mist is formed into a columnar shape by shape-forming air and high-voltage static electricity. Mainly used for electrostatic spraying of paint on metal products. The rotary cup atomizer has higher efficiency and better atomization effect, and the measured paint utilization rate can reach more than twice that of traditional spray guns.

Basic parameters of Tool

Tool trajectory diagram