Introduction to Robot Products

BRTIRPZ1508A type robot is a four-axis robot developed by BORUNTE, it applies full servo motor drive with fast response and high position accuracy. The maximum load is 8kg, the maximum arm length is 1500mm. Compact structure achieves a wide range of movements, flexible sports, precise. Suitable for dangerous and harsh environments, such as stamping, pressure casting, heat treatment, painting, plastic molding, machining and simple assembly processes. And in the atomic energy industry, completing the handling of hazardous materials and others. It is suitable for punching. The protection grade reaches IP40. The repeat positioning accuracy is ±0.05mm.

Basic parameters of robot

Robot trajectory diagram

No further notice if the specification and appearance are changed due to improvement and other reasons. Thank you for your understanding.

Precautions for Storage and Handling Caution:

Do not store or place the machine in the following environment, otherwise it may cause fire, electric shock or machine damage.

1. Places exposed to direct sunlight, places where the ambient temperature exceeds the storage temperature conditions, places where the relative humidity exceeds the storage humidity, or places with large temperature differences or condensation.

2. Places close to corrosive gas or flammable gas, places with a lot of dust, salt and metal dust, places where water, oil and medicine drip, and places where vibration or shock can be transmitted to the subject. Please do not grab the cable for transportation, otherwise it will cause damage or failure of the machine.

3. Do not stack too much products on the machine, otherwise it may case machine damage or failure.

Introduction to Tool Products

BORUNTE non-magnetic splitter can be used inautomated scenarios such as stamping, bending, orother sheet materials that require separation.ltsapplicable plates include stainless steel plate.aluminum plate,plastic plate, metal plate with oil or filmcoating on the surface.etc.Using mechanical split.ting, the main push rod is pushed by a cylinder toachieve splitting. The main push rod is equippedwith racks,and the tooth pitch varies according tothe thickness of the plate. The main push rod has thefreedom to move vertically upwards, and when thecylinder pushes the rack through the main push rodto contact the sheet metal, it can freely separate onlythe first sheet metal and achieve separation.

Basic parameters of Tool

Tool trajectory diagram